- This HX711 module uses 24 high precision A/D converter chip hx711. It is a specially designed for the high precision electronic scale designwith two analog input channelthe internal integration of 128 times the programmable gain amplifier.
- You need to connect load cell wtih HX711 module like this, Red to E+, Black to E-, Green to A+, White to A-.
- On-chip active low noise PGA with selectable gain of 3264 and 128.
- Simple digital control and serial interface: pin-driven controlsno programming needed.
- Suitable for arduino and raspberry pi. The input circuit can be configured to provide a bridge type pressure bridge (such as pressureweighing sensor mode).
Feature:
On-chip active low noise PGA with selectable gain of 32, 64 and 128
On-chip power supply regulator for load-cell and ADC analog power supply
On-chip oscillator requiring no external component with optional external crystal
On-chip power-on-reset
Simple digital control and serial interface: pin-driven controls, no programming needed
Selectable 10SPS or 80SPS output data rate
Simultaneous 50 and 60Hz supply rejection
Current consumption including on-chip analog power supply regulator: normal operation <1.5mA, power down <1uA
Operation supply voltage range: 2.6 ~ 5.5V
Operation temperature range: -40 ~ +85℃
PCB Size: 35mmx20mm
Weight Sensor:
Four leads, easy to use
5-10V drive voltage applied, the force is directly output as a voltage change signal
Dimensions: 13.5mm * 13.5mm * 81mm
Sensor through the screw hole at one end fixed and the other end to keep floating state, applying gravity following the direction indicated by label
Particular attention must not directly push the white plastic cover part, so as not to damage the sensor
Connection:
Red to E+
Black to E-
Green to A+
White to A-
Packing List:
1 x Weight Sensor
1 x HX711 Module